1. How Pymeter keep watch over temperature?
Temperature controller is actual Heating/Cooling controller, thus MUST SET ON-Temp to turn ON Heating/Cooling, and MUST SET OFF-Temp to turn OFF Heating/Cooling.
Heating starts at LOW Temp [ON-Temp(1oN, 2oN)], stops at HIGH Temp [OFF-Temp(1oF, 2oF)], thus for heating MUST SET 1oN(2oN) LESS than 1oF(2oF);
In heating mode, 1oN(2oN) is the minimum temp you allow, 1oF(2oF) is the maximum temp you allow.
Cooling starts at HIGH Temp [ON-Temp(1oN, 2oN)], stops at LOW Temp [OFF-Temp(1oF, 2oF)], thus for cooling MUST SET 1oN(2oN) GREATER than 1oF(2oF).
In cooling mode, 1oN(2oN) is the maximum temp you allow, 1oF(2oF) is the minimum temp you allow.
2. Reading temp is inaccurate?
Every Pymeter controller is calibrated before come out of factory, it is reading temp appropriately!
Please don’t compare it to common inaccurate thermostat、thermometer or temp gun. If you doubt Pymeter controller accuracy, please calibrate with ice-water mixture (it is 32F when ice is melting), and you’ll see which device is accurate then.
3. Beeper keeps sounding?
Probably it is the Alarm settings ( AL、AH、d7 ) you set are NOT the right temperature you wish to have. AL is low temperature alarm(it sounds when current temp is AL or Lower), AH is high temperature alarm(it sounds when current temp is AH or Higher), d7 is difference alarm(it sounds when the temp deviation between sensor 1 and sensor 2 is over d7). If you don’t need alarm function, please don’t change the values of AL、AH、d7, the default values frequently won’t trigger alarm. You’ll be able to factory reset by switching temp unit from F to C in setting.
Please download User Manual PDF in Product information.
Make sure this fits by entering your model number.
✓【Dual Probes】Quite different from other thermostats, Pymeter temperature controller is equipped with 2 waterproof accurate sensors, make it conceivable to keep watch over 2 sockets for heater and cooler at the same time or one after the other.
✓【Dual Sockets】Each outlet has independent temperature controlled switch and it intelligently identify heating or cooling mode via ON & OFF set-point, it is very easy and flexible to keep target at desired temperature range.
✓【Safe and Reliable】Enhance High and Low Temperature Alarm; Temperature Difference Alarm, this is very helpful to keep target safe from malfunction of any one probe. Cooking fishes NEVER happen!
✓【Enhanced Functions】Power-Off Memory; Power-On Delay; Temperature Calibration.
✓【Widely Used】Pre-wired, just plug in and play, suitable for quite a lot of applications: kimchi refrigerator, garage freezer, carboy heater, home brew kit, chicken coop water heater, water chiller, swamp cooler, seedling heat mat, reptile heating pad, heat lamp, oven thermostat, beer brewing kit, fermenter fermentation bucket, heat mat for plants, grow tent heater etc.